Gastroback 42606 Design Espresso Plus User Manual Page 16

  • Download
  • Add to my manuals
  • Print
  • Page
    / 30
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 15
waste. Do not dispose of the espresso powder in the sink, otherwise the drain could be
clogged.
3. The filters sit firmly in the portafilter. Lift the filter by the recesses
on the sides of the portafilter to remove it from the portafilter.
4. Rinse the filter and portafilter with clear water and allow these
components to dry.
FROTHING MILK
WARNING: The steam wand and the attachment are very hot after use for some time.
Always check first that these components have cooled down before you touch these.
This espresso machine is equipped with a swiveling steam wand and a black attachment for
frothing milk. This allows you to quickly and easily produce milk foam. If you need only a litt-
le milk foam, than remove the attachment and use only the steam wand for frothing the milk.
Removing the Attachment
Make sure first, that this part has cooled down. Then pull the attachment
gently downward from the steam wand. Rotate the attachment during
process slightly back and forth.
Replacing the Attachment
Insert the attachment with the narrow end onto the steam wand and push
upwards to the top until it clicks into place. The attachment should not
wobble or fall off. Rotate the attachment during the process might slightly
back and forth.
Note:
The attachment has two resistors inside and is placed properly,
when you have pushed the attachment for snapping up over the first
resistance onto the steam wand. The steam wand should be located
only in the narrow part of the attachment and must not protrude from
the top down.
Using the Steam Function
The heating indicator lights up when you set the selector switch to the
steam position. Note: Make sure before each use that the selection
switch is positioned to ›standby‹-position (middle). If the selector
switch is positioned to the right (in brewing position), after preheating,
hot water emerges from the group head. If the selector switch is positi-
oned to the left (steam/hot water), hot steam or hot water (depending
on the setting) emerges from the steam wand. Important: Make
sure that the black folding switch is in the correct position: steam or
hot water.
Attach-
ment
Steam
wand
Steam Hot Water
46
Page view 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 29 30

Comments to this Manuals

No comments