Gastroback Design Mincer Operations Instructions Page 11

  • Download
  • Add to my manuals
  • Print
  • Page
    / 15
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 10
Disassembling
WARNING: To avoid injury and damages of the appliance turn the applianceOFF
and then wait for approx. 6 seconds to be certain that the motor is no longer
running. Always pull the plug before you star t disassembling or cleaning
the appliance.
1. Switch off the mincer and disconnect the power supply cable
from the mains. Check that the motor has completely stopped.
2. Detach the worm housing from the motor block.
3. Unscrew the closing ring tur ning it counterclockwise.
TIP: If the closing ring is screwed on to tight you can use a
screwdriver as shown in the picture 10.
4. Remove the mincer plate. If necessar y insert a knife or screwdriver between the mincer
plate and the worm housing to pry out the mincer plate.
5. Remove the crossed-blade knife and pull out the wor m or if you used the chopper attachment
remove them.
TIP: If the tools are stucked knock the mincer carefully on a stable cutting board. The mincer
plate should be facing up.
ATTENTION: Be careful not to damage your bench top, the cutting board or the mincer .
6. Remove meat residues.
Operate as described:
ATTENTION: Never put the appliance or par ts of the appliance
in the dishwasher or use abrasives for cleaning! This will cause
discoloration and corrosion.
7. Wash all parts thoroughly in hot soapy water. Do not use aggressive detergents. The parts
are not suitable for dishwasher . Soak par ts with desiccated food leftovers a few minutes in
warm soapy water and use a nylon cleaning brush or cleaning sponge for cleaning. Rinse
all parts with running water and dr y them accurately.
WARNING: Ensure that the switch and cable do not come into contact with water!
Should this inadvertently happen, all parts must be completely dry before the appliance is used
again. Never let water or other liquids run into the motor housing. Never clean the line
cord or the appliance in the dishwasher , poor liquids over the appliance or douse or dip it
in water or other liquids. In case that water or other liquids ran into the appliance while oper-
28
41400_Manual_Fleischwolf_Juli2009.qxp 19.11.2009 09:24 Seite 28
Page view 10
1 2 ... 6 7 8 9 10 11 12 13 14 15

Comments to this Manuals

No comments