Gastroback 42518 Design Rice Cooker Pro User Manual Page 12

  • Download
  • Add to my manuals
  • Print
  • Page
    / 14
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 11
2. Check the power cord: The plug contacts on the plug must always be clean, bright and
dry, the insulation must never be broken at any point or damaged. Replace the cable if it is
damaged. Keep the power cord in a clean, dry place.
3. Remove the steam outlet and dry the inside of the steam outlet. (See: ›Steam Outlet‹)
4. Remove the inner pot from the appliance.
5. Rinse the following components and accessories in warm soapy water: the inner pot and
inner steamer, steam outlet, spoon and measuring cup.
6. Dampen a clean cloth or a soft sponge with warm soapy water; sponge or cloth should
not drip when pressed.
7. Gently wipe the appliance from the outside. Wipe the heating tank from the inside.
8. Clean the stainless steel surfaces of hot plate and temperature sensor in the bottom of the
heating tank very carefully. Stubborn caking can be removed carefully with a fine sandpa-
per ( 320 grit ). Take care not damage the coatings on the side surfaces of the heating tank.
9. Dampen a clean cloth with clean water and wipe lightly after that.
10. Dry the equipment and all components carefully.
STEAM OUTLET
The steam outlet is located in the center of the lid.
WARNING: The lid of the steam outlet gets very hot during operation. First, turn off the
appliance, unplug the power cord from the outlet and let the appliance cool down before
opening the steam outlet.
ATTENTION: In the lid of the steam outlet a seal is inserted. Never scratch or poke with
pointed or sharp objects under the edge of steam outlet. Be careful not to damage the seal.
To open and close the steam outlet lid:
1. Grasp, with appliance lid closed, with the index finger in the recess at the steam outlet.
Then turn the lid of the steam outlet with the other hand gently a little bit counterclockwise until
the steam outlet lid can simply be lifted .
2. Check that the seal is correctly inserted inside the edge of the lid of the steam outlet. If the
seal is deformed, cracked or crusty, then replace the seal.
3. Dry after operation of the device, the inner sides of the steam outlet. The lid of the steam
outlet can be cleaned in warm soapy water with a soft cloth and then dry. Set the lid back
on the steam outlet.
Note: The steam outlet lid can be inserted only in one direction. If the separator lid is properly
inserted and locked, then the slot of the steam opening shows to rear panel and the steam
outlet lid does not extend beyond the control cover.
4. To lock the steam outlet lid, turn it a bit clockwise. Do not apply any violence, making sure
not to dislodge the steam outlet lid.
Never operate the appliance without the separator lid!
26
Page view 11
1 2 ... 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments