Gastroback 42399 Automatic Milk Frother - Mini User Manual Page 13

  • Download
  • Add to my manuals
  • Print
  • Page
    / 14
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 12
29
Troubleshooting guide
Problem Possible Cause Solution
Froth whip is not rotating The froth whip is not properly seated in
the whip holder.
The lid is not properly placed.
The power cord is not fully plugged into
the base of the appliance or the wall
outlet.
Make sure that the froth whip is placed in the
whip holder and locked into place. Check that
the whip holder is fully snapped onto the lid.
Make sure that the lid is properly placed on
the electrical connector of the appliance.
Check all electrical connections.
Froth overows You are using too much milk. For optimal results, add milk to FILL LINE.
The appliance is not properly
frothing
The froth whip and/or the whip holder is
not snapped properly in the lid.
You are not using proper amount of milk.
Residue is building up on the bottom,
inside of the pitcher, and/or the whip.
You are using a brand or type of milk
that doesn’t froth.
The pitcher has not cooled down.
See chapter ›Operation‹ for further reference.
For optimal results, add milk to FILL LINE.
Remove all milk residue from the pitcher with
a sponge or a sofr cleaning brush. Operate
the appliance lled with water up to the FILL
LINE.
Use cold, fresh milk. Occasionally, a brand or
type of milk may not froth as well.
Wait for approximately three minutes after
every frothing cycle and then rinse the pitcher
in COLD water. Add COLD water into the emp-
ty pitcher and wait a few minutes until cool.
The appliance does not restart and
the operating light stays on
The lid has been removed while the
appliance was in operation.
Unplug the appliance from power outlet
and reinsert the plug. Press the ON switch to
restart.
The appliance does not operate or
the operating light is not on
The appliance is not plugged in into the
power outlet.
The appliance is in safety cool down
period.
The ON switch is not properly engaged.
Make sure the appliance is plugged into a
power outlet and the power receptacle into
the appliance.
Wait for approximately three minutes after
every frothing cycle and then rinse the pitcher
in COLD water. Add COLD water to empty
Pitcher and wait a few minutes until cool.
Press the ON switch rmly.
Page view 12
1 2 ... 8 9 10 11 12 13 14

Comments to this Manuals

No comments