Gastroback 41402 Mincer Pro User Manual download pdf (Page 12)

CARE AND CLEANING

WARNING: Never hold your face or other body parts over the feed funnel when the

motor is running because little pieces of food could be thrown out of the feed funnel. Never

put foreign substance or hard objects into the feed funnel.

Before the mincer is used for the first time, all parts – with the exception of the motor block

– must be thoroughly cleaned in warm soapy water.

Disassembling

WARNING: To avoid injury and damages of the appliance turn the appli-

ance off and then wait for approx. 6 seconds to be certain that the motor

is no longer running. Always pull the plug before you start disassembling

or cleaning the appliance.

1. Switch off the mincer and disconnect the power cord from the mains. Check that the

motor has completely stopped.

2. Detach the worm housing from the motor block.

3. Unscrew the closing ring turning it counter clockwise.

Tip: If the closing ring is screwed on to tight you can use a

screwdriver as shown in the picture 10.

4. Remove the grinding disc. If necessary insert a knife or

screwdriver between the grinding disc and the worm housing

to pry out the grinding disc.

5. Remove the crossed-blade knife and pull out the worm or if

you used the chopper attachment remove them.

Tip: If the tools are stuck, knock the mincer carefully on a

stable cutting board. The grinding disc should be facing up.

ATTENTION: Be careful not to damage your bench top, the cutting board or the mincer.

6. Remove meat residues.

Operate as described:

ATTENTION: Never put the appliance or parts of the appliance in the dish-

washer or use abrasives for cleaning!

7. Wash all parts thoroughly in hot soapy water. Do not use aggressive detergents. The

parts are not suitable for dishwasher. Soak parts with desiccated food leftovers a few min-

utes in warm soapy water and use a nylon cleaning brush or cleaning sponge for cleaning.

Rinse all parts with running water and dry them accurately.

WARNING: Ensure that the switch and cable do not come into contact with water!

Should this inadvertently happen, all parts must be completely dry before the appliance is

used again. Never let water or other liquids run into the motor block. Never clean the

power cord or the appliance in the dishwasher, poor liquids over the appliance or douse

or dip it in water or other liquids. In case that water or other liquids ran into the appliance

while operating turn off the appliance immediately, pull the plug and dry the appliance

with a clean cloth.

1 2 ... 7 8 9 10 11 12 13 14 15 16

No comments

Gastroback 41402 Mincer Pro User Manual Page 12