Gastroback 40127 Design Multi Juicer User Manual download pdf (Page 11)

Step 5:

As fruit and vegetables are processed, juice will flow into the juice jug and the separated

pulp will accumulate in the pulp container.

ATTENTION: Do not allow the pulp container to overfill as this may affect the operation

of the appliance (refer to disassembling instructions). Reassemble machine to continue

juicing. To minimise cleaning, line the pulp container with a plastic freezer bag to collect

the pulp. Pulp can then be used in other dishes (see recipes), or as compost for the garden

or discarded (see page 17).

Empty the pulp container during juicing

The pulp container can be emptied during juicing by turning the appliance ‘Off’ at the control

panel and then carefully removing the pulp container. Remove the pulp container by tilting the

pulp container slightly to the right and unlatch it from under the juicer cover and the

container support extending from under the motor base. Replace the empty pulp container

into position before continuing to juice.

Overheat protection

The Design Multi Juicer will automatically stop operating if the motor is stalled for more than

10 seconds. This is a safety feature. Either too much food is being processed at one time

or the pieces are not small enough. Try trimming food, cutting food into smaller pieces of

even size and/or processing a smaller amount per batch. To continue juicing, reset the

appliance by pressing the ‘On/Off’ switch on the control panel to ‘Off’, then turn the appliance

back on by pressing the ‘On/Off’ switch to ‘On’.

Disassembling your Design Multi Juicer

WARNING: Always turn the appliance off and pull the

plug when the appliance is not in use or when disassembling,

moving or cleaning the appliance.

Step 1:

Ensure the appliance is turned off by pressing the ‘On/Off’

switch on the control panel to ‘Off’. Then switch the appliance

off at the power outlet and unplug the cord.

Step 2:

Remove the pulp container by tilting the pulp container slightly

to the right and unlatch it from under the juicer cover and the

container support extending from under the motor base (picture A).

Step 3:

Use the grip handle located on the safety locking arm to lift

the locking arm from the juicer cover and lower down out of

position (picture B).

40127_DesignMultiJuicer_Manual_Englisch.qxp 03.09.2008 15:53 Seite 11

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

No comments

Gastroback 40127 Design Multi Juicer User Manual Page 11